Línea directa de servicio gratuito
+49(0)7722-7782266

Instructions


Congratulations on your new Black Forest cuckoo clock. 

The cuckoo clock shop carefully packaged your clock. Make certain your cuckoo clocks box is placed top up on a table before unpacking. Take out the top items, such as pine cone weights, then remove the foam covering, then remove the clock. Black forest clocks include various supplied parts, depending upon the design and the model. Your cuckoo clock shop packed these parts separately. Place the various parts upon your work table.
  • Remove the back of the clock 
To remove the clocks back, insert a pen or pencil into the bottom hole and lever the pen beneath the covers lower side and lift the bottom cover off the Black Forest clocks inner workings. Remove the paper strip from the back cover. 
  • Disengage the cuckoo clocks security clamps 
The cuckoo clocks security clamps are located on both sides of the inner clock workings and are tagged Pull. Reach inside the clock and gently pull each clamp off and out. Replace the cuckoo clocks back with the hole positioned at the bottom of the clock, upside down. 
  • Assembling the front of your clock 
Turn the clock face up on the table. If you have a deer head, secure the head between the oak leaves with the small screw supplied by your cuckoo clock shop. Gently push both antlers into the deer head. Refer the cuckoo clock shop instruction sheet for assembly of any additional parts, for instance, the bell-shaped sound cup. The sound cup, like the antlers, is gently pressed into position. Now, attach the deer head appendage onto the very top of the clock by sliding the entire piece down into the grooved fittings. 
  • Hanging your clock 
The cuckoo clock shop recommends you hang your clock approximately 6.5 feet from the floor. Place your clock on the nail in a balanced position. Look beneath the clock. Unfasten and open the small parcel found there. This will enable the chains to hang without hindrance. Now remove the wire that was used for transport purposes only. The weights and the pendulum can now be fitted. Attach the pendulum onto the hanging key towards the back of the bottom of the clock. Attach the pine cones to the hooks in front of the pendulum key. Open the bar enclosing the cuckoo’s little house. 
  • Settings 
Your cuckoo clocks start and stop lever is either on the side panel, or the bottom. Slide side levers up and pull bottom levers down. This regulates the cuckoo’s call. To set the time, turn the cuckoo clocks long hand clockwise into position, then flick the pendulum to get it moving back and forth. To set the time exactly, remove the pendulum from its hook. The cuckoo clock shop created pendulum leaf to slide up and down. If time is running too fast, slide the pendulum leaf down. If time is too slow, slide the leaf up. Adjustments for accuracy might have to be made over a few days.

Instructions